What should I do if the screw of the injection molding machine leaks?
What is an injection molding machine? It is a kind of equipment that makes plastic into various shapes of plastic products, and it is widely used in factories. When ordinary workers use the injection molding machine, the screw of the injection molding machine may leak. How to deal with this kind of thing? Is it to wrap the glue?
What should I do if the screw of the injection molding machine leaks? Be sure to check the cause of the glue leakage first, and then solve it later. Checking the glue leakage is mainly to check the following three aspects:
1. Check whether the processing temperature is set correctly. If the temperature is too low and the plastic cannot be melted, the screw will not rotate and the glue will not be melted;
2. Check whether the settings of melt pressure, speed and position are correct. If any of the pressure and speed is 0, the glue will not melt. If the position of the screw is greater than the set melting position, the glue will not be melted. If the melt pressure and speed are not high enough, the screw may not rotate.
3. Check whether the oil motor of the injection molding machine is turned on.
How to deal with screw encapsulation? When using an injection molding machine, if there is a screw encapsulation, calcium carbonate, screw cleaning agent and Sprite can be used to clean the encapsulation. The effect is quite good. In addition, there is a very simple method, which is to wrap the screw with plastic and rotate it together, so that the plastic can be cleaned, and it is more convenient.
The above is the editor’s answer to “What should I do if the screw of the injection molding machine leaks? How to deal with the screw encapsulation?” The injection molding machine is a kind of equipment often used by workers. After normal use, you must pay attention to maintenance and maintenance, and clean the injection molding regularly. Machine, so that there will be no problems.
Link to this article： What should I do if the screw of the injection molding machine leaks?
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:https://www.cncmachiningptj.com/，thanks！